AR · Radiant Arrow log-periodic antenna

AR ATR26M6G-1

One log-periodic antenna from 26 MHz to 6 GHz for radiated immunity, about 75 % smaller than a conventional design of the same band.

Request a quotation Spec sheet at ar.ametek-cts.com
AR ATR26M6G-1 Radiant Arrow log-periodic antenna
Key facts

AR ATR26M6G-1 at a glance

  • 26 MHz to 6000 MHz in one antenna
  • Input power up to 5000 W
  • Bent-element design: about 75 % smaller, with gain and beamwidth kept
  • Gain 6 dB over isotropic from 80 MHz to 6 GHz, flat within ±1.5 dB
  • Very low VSWR
  • Overall width 2.18 m, including the polarisation pivot
  • Polarisation is changed without removing the antenna from its positioner
  • Mounts on the AP5010B positioner or the TP1000BM3 tripod; built for outdoor use as well
  • A calibrated version (suffix CC) is available for emission measurements

Figures from the manufacturer's product page. Specifications are subject to change; the datasheet governs. Quotations on request.

Where it fits

What the ATR26M6G-1 is used for

A conventional log-periodic antenna that reaches down to 26 MHz is several metres wide, and in a moderate-size chamber it loads the room and loses field. The Radiant Arrow folds the long elements back, which is how it fits a compact chamber without giving up gain or beamwidth.

Because one antenna covers 26 MHz to 6 GHz, most of an ISO 11452-2, MIL-STD-461 RS103 or IEC 61000-4-3 test runs without an antenna change. It is matched to the AR A, W and S series amplifiers.

Typical standards for this product

MIL-STD-461 RS103ISO 11452-2ISO 11451-2RTCA/DO-160 Section 20IEC 61000-4-3
Calibration

Calibrated on site, by the people who supplied it

Antennas are covered by our antenna calibration service. Calibration is carried out in your laboratory by the LAB Support Southeast Asia team, under the A2LA accredited ISO/IEC 17025 scope of LAB Support Ltd.

Antenna calibration →
Related

Goes with the ATR26M6G-1

AR 500W1000C amplifier →AR 250S1G6C amplifier →Frankonia EMC chambers →All AR models →
Frequently asked

AR ATR26M6G-1 in Malaysia

Why is the AR ATR26M6G-1 so much smaller than other log-periodic antennas?

Its long low-frequency elements are bent back instead of straight. The manufacturer states a size reduction of about 75 % with gain and beamwidth maintained.

Where can I buy the AR ATR26M6G-1 in Malaysia?

ICX Lab Services in Penang is the authorised distributor of AMETEK CTS products, and AR is one of the brands under AMETEK CTS, together with EM TEST and Teseq. Send us the model number through the contact page or WhatsApp and we reply with a configuration and a quotation. Quotations on request.

Who installs and supports the ATR26M6G-1 after delivery?

We do. ICX Lab handles delivery, installation and training, and coordinates factory service, firmware and repairs with AMETEK CTS on your behalf.

AR RF/Microwave Instrumentation is part of AMETEK Compliance Test Solutions. Product name, specifications and image are taken from ar.ametek-cts.com.

Need a quotation for the ATR26M6G-1?

Tell us the standards you test to and we will configure it with the accessories it needs.

Request a quotation   All AR models

Tell us what you need to test

We reply within one working day with a quote or a plan.

Contact us